Kawai MP7 User Manual Page 117

  • Download
  • Add to my manuals
  • Print
  • Page
    / 148
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 116
117
Appendix
This page contains instructions for updating the system software of the MP7, when issued by Kawai.
Please read these instructions thoroughly before attempting to perform the software update.
Checking the software version
To check the current software version installed on the MP7,
press and hold the STORE button, then turn the instrument ON.
The current software (Program) version will be shown on the
rst line of the LCD display.
If the Program version number is greater than or equal to the
update version, no further action is necessary.
* Turn the instrument o and on to return to normal operation.
If the Program version number is lower than the update version,
please continue to follow the instructions below.
1. PreparetheUSBmemorydevice
Extract the software update ZIP le and copy the included .SYS
les to the root folder of a USB memory device.
* USB devices should be formatted to use the ‘FAT’ or ‘FAT32’ lesystems.
2. Connect the USB memory device
While the instrument is turned o:
Connect the prepared USB memory device to the USB port.
3. Start the update
Press and hold buttons 6, 7, and 8 in the middle row of the
SOUND/SETUP section, then turn the instrument ON.
The update process will start automatically after a few seconds,
and status messages will be shown in the LCD display.
* Do not remove the USB memory device while the software update is in
progress.
4. Finish the update, disconnect the USB memory device
After approximately 60-90 seconds (depending on the number
of update les), a message will be shown in the LCD display,
indicating that the software update has been successful.
Disconnect the USB memory device, then press and hold the
POWER switch to turn the instrument OFF. When the instrument
is turned ON, the updated software will be used automatically.
* If the software update is unsuccessful, restart the process from step 1.
Software Update
hold
Program
version
hold
hold
hold
Page view 116
1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 147 148

Comments to this Manuals

No comments