Kawai MP10 User Manual download pdf (Page 87)

Appendix

Software Update

This page contains instructions for updating the MP10’s system software.

Please read these instructions thoroughly before attempting to perform the software update.



Checking the software version

To check the current software version installed on the MP10,

press and hold the STORE button, then turn the instrument on.

The current software (Program) version will be shown on the

rst line of the LCD display.

If the Program version number is greater than or equal to the

update version, no further action is necessary.

* Turn the instrument o and on to return to normal operation.

If the Program version number is lower than the update version,

please continue to follow the instructions below.

1. PreparetheUSBmemorydevice

Copy the MP10_040.SYS update le to the root folder of a USB

memory device.

* The USB device should be formatted to the ‘FAT’ or ‘FAT32’ lesystem.

2. Connect the USB memory device

While the instrument is turned o:

Connect the prepared USB memory device to the USB port.

3. Start the update

Press and hold buttons 4, 5,and 6 in the SETUP section, then

turn on the instrument.

The update process will start automatically after a few seconds,

and status messages will be shown in the LCD display.

* Do not remove the USB memory device while the software update is

in progress.

4. Finish the update, disconnect the USB memory device

After approximately 30 seconds, a message will be shown in

the LCD display, indicating that the software update has been

successful.

Disconnect the USB memory device, then turn the instrument

o and on. The updated software will be used automatically.

* If the software update is unsuccessful, restart the process from step 1.

hold

Program version

hold

1 2 ... 82 83 84 85 86 87 88 89 90 91 92

No comments

Kawai MP10 User Manual Page 87